Hi guys, Welcome to the Advanced Video Search Engine, and you are watching How to Install Kitchen Cabinets | Ask This Old House. That video is uploaded by This Old House at 2016-11-17T19:00:00-08:00. We are promoting this video only for entertainment and educational purpose only. So, I hope you like & enjoy it. [5xN9kPD7ddU]
| Name | How to Install Kitchen Cabinets | Ask This Old House |
| Video Uploader | Video From This Old House |
| Upload Date | This Video Uploaded At 18-11-2016 03:00:00 |
| Video Discription | This Old House general contractor Tom Silva shares expert tips and techniques for installing new kitchen cabinets. (See below for a shopping list, tools, and steps.) SUBSCRIBE to This Old House: http://bit.ly/SubscribeThisOldHouse Shopping List for How to Install Kitchen Cabinets: Kitchen cabinets [https://amzn.to/2ZEdM2g] 3-inch screws [https://amzn.to/2Prpf1l], to fasten cabinets to walls Wood shims [https://amzn.to/34sYQDw], for leveling and plumbing cabinets 2x4 blocking [https://amzn.to/2ZGAurp], to secure peninsula or island cabinets Tools for How to Install Kitchen Cabinets: 2-foot [https://amzn.to/2ZLPXpd] and 6-foot [https://amzn.to/2ZEDvs7] levels, for determining level and plumb alignment Tape measure [https://amzn.to/2MXmOkN] Screwdriver [https://amzn.to/2N3Nlxd], to unscrew doors Cordless drill [https://amzn.to/2ZQS4nM], for drilling holes Impact driver [https://amzn.to/2LraKFj], to drive screws Utility knife [https://amzn.to/2MXO9n9], for trimming shims Steps for How to Install Kitchen Cabinets: 1. Check the ceiling for level in two directions. If it’s out of level, find the low spot and use it as the measuring reference point. 2. Measure down from the ceiling (or low spot) 33 inches in several places and mark the walls. These marks represent the bottom of the upper cabinets. 3. Connect the marks with a long level and a sharp pencil to produce a level line along the kitchen walls. 4. Mark the stud locations on the walls, then measure and transfer stud locations to the back of the upper cabinets. (If you prefer to proceed with one cabinet at a time, begin with the one that will hang in the corner of the kitchen, and continue with consecutive cabinets.) 5. Pre-drill a screw-shank clearance hole through the cabinet backs at each stud location. 6. Unscrew and remove the cabinet doors; place the doors in a nearby room for safekeeping. 7. Hold the first wall cabinet in place in the corner of the kitchen. Be sure the bottom of the cabinet is even with the level line marked in Step 3. 8. Drive one screw through the upper back of the cabinet and into the wall stud. 9. Check the cabinet for plumb with a level. If necessary, slide shims behind the cabinet. Then drive in the remaining screws to secure the cabinet. Trim the shims with a utility knife. 10. Repeat the previous six steps to install the rest of the upper cabinets. 11. To prepare for installing the base cabinets, lay a 6-foot level on the floor in several places to identify the high spot. 12. From the floor’s high spot, measure up 34_ inches and mark the wall. 13. From that mark, draw a level line around the kitchen walls. This line represents the top of the base cabinets. 14. Install the sink base cabinet first, centering it under the window. 15. Drive shims under the sink cabinet, if necessary, to raise it flush with the 34_-inch reference line marked on the wall. 16. Fasten the sink base cabinet to the wall studs with 3-inch screws. Before fully tightening the screws, slip a shim behind the cabinet to fill any void. 17. Check the cabinet for level from front to back; slide shims under the front of the cabinet, if necessary, to level it. Trim the shims with the utility knife. 18. Install the remaining base cabinets in a similar manner. 19. To secure peninsula or island cabinets, screw 2x4 blocking to the floor. Set the cabinets over the blocking, then screw through the toekick and into the blocking. 20. Cover the exposed end of the cabinets with a decorative panel. Drive in short screws from inside the cabinet. 21. Install all the drawers and doors. 22. Fabricate a filler strip to fit alongside the base cabinet that abuts the range. Fasten the filler by screwing through the cabinet face frame. 23. Once the base cabinets are installed, make a template for the new countertop. Watch new episodes of Ask TOH: http://www.thisoldhouse.com/toh/tv/ask-toh/video/0,,,00.html About Ask This Old House TV: Homeowners have a virtual truckload of questions for us on smaller projects, and we're ready to answer. Ask This Old House solves the steady stream of home improvement problems faced by our viewers—and we make house calls! Ask This Old House features some familiar faces from This Old House, including Kevin O'Connor, general contractor Tom Silva, plumbing and heating expert Richard Trethewey, and landscape contractor Roger Cook. Follow This Old House and Ask This Old House: Facebook: http://bit.ly/ThisOldHouseFB Twitter: http://bit.ly/ThisOldHouseTwitter http://bit.ly/AskTOHTwitter Pinterest: http://bit.ly/ThisOldHousePinterest Instagram: http://bit.ly/ThisOldHouseIG http://bit.ly/AskTOHIG Tumblr: http://bit.ly/ThisOldHouseTumblr For more on This Old House and Ask This Old House, visit us at: http://bit.ly/ThisOldHouseWebsite How to Install Kitchen Cabinets | Ask This Old House https://www.youtube.com/user/thisoldhouse/ 5xN9kPD7ddU |
| Category | Howto & Style |
| Tags | This Old House | Ask This Old House | DIY | Home Improvement | DIY Ideas | Renovation | Renovation Ideas | How To Fix | How To Install | How To Build | kitchen cabinets | construction | carpenter | home repair | diy | renovation | remodeling | kitchen | cabinetry | tom silva | kevin o'connor | norm abram | richard trethewey | roger cook | tom silva this old house | tom silva house | tom silva construction | tom silva tools | tommy silva |
