Hi guys, Welcome to the Advanced Video Search Engine, and you are watching How to replace LCD Screen on HP 15 laptop. Model 15-dy1013ca. Step-by-step instructions. That video is uploaded by LaptopScreen.com at 2022-12-05T16:08:40-08:00. We are promoting this video only for entertainment and educational purpose only. So, I hope you like & enjoy it. [Wl8MHnDx-rA]
| Name | How to replace LCD Screen on HP 15 laptop. Model 15-dy1013ca. Step-by-step instructions |
| Video Uploader | Video From LaptopScreen.com |
| Upload Date | This Video Uploaded At 06-12-2022 00:08:40 |
| Video Discription | https://www.LaptopScreen.com/ https://www.laptopscreen.com/English/brand/HP/ This is a guide on replacing an LCD on a HP 15 inch laptop Model# 15-dy1013ca For the replacement process we'll need the following tools: - a plastic pick - and tweezers To begin shut down the laptop and disconnect the power cord. Now we can remove the bezel. Start from the left side. Gently pulling the inner edge of the bezel away from the glass. Once the edge is unsnapped go around the perimeter unsnapping the tabs underneath. Use a plastic pick when needed. Unsnap the bezel along the hinge cover. Close the laptop and turn it sideways. Use a plastic pick to separate the bezel along the bottom edge. Put the bezel aside. The screen is held in place with two strips of double-sided adhesive, and there are two plastic pull tabs that should allow you to pull the strips out. Using tweezers pick the right tab and start pulling the adhesive strip away, releasing the right side of the screen. Discard the used adhesive strip. Repeat the same action on the left side of the screen. Place the LCD on the keyboard. Peel off the tape securing the video connector. Using both hands disconnect the cable. Discard the old screen. At this point the new LCD panel can be installed. Place the screen on the keyboard. And using both hands reconnect the video cable. Secure in it with a tape. CAUTION! It is very important not to force any of the connectors. As well you must not twist or slant the connector when plugging it in. Your new LCD is likely to come with no adhesive. We offer standard double-sided strips for such repairs on our site: laptopscreen.com. Before we can apply the adhesive strips we have to thoroughly clean the surfaces, both on the LCD and the back cover. Use alcohol and a paper towel or any other soft material. Apply adhesive strips to the back of the LCD insuring that the pull tabs will be accessible above the new screen. Remove the film from the adhesive. Lift the screen up and press firmly along the edges to catch the adhesive. At this point we can test the new screen. Press the power button and if start up graphics appear, the screen is working and we can finish the replacement process. Turn the laptop off. Remove the protective film from the LCD. Start replacing the bezel. Pull the hinge cover away to make sure that the bottom side of the bezel is in place. Then go around the perimeter pressing firmly until all tabs are snapped in place. Use one hand to support the back cover while snapping tabs along the bottom side of the bezel. Close the laptop and flip it over sideways. Make sure that the bezel is snapped along the hinge cover. Turn the laptop on, and we are done! Wl8MHnDx-rA |
| Category | Science & Technology |
| Tags | HP | HP laptop | screen replacement | 15-dy1013ca | laptop | broken skreen | LCD | LCD screen | fixing | installing | repiar | Dell | Latitude | fix | repair | manual | tutorial | instructions | computer | notebook | how-to | DIY |
