Hi guys, Welcome to the Advanced Video Search Engine, and you are watching LG WT1101C* & WT1201C* Drain Pump Runs Continuously ( Updated ). That video is uploaded by Rod Ross at 2020-04-26T20:39:54-07:00. We are promoting this video only for entertainment and educational purpose only. So, I hope you like & enjoy it. [1X74paodnkk]
| Name | LG WT1101C* & WT1201C* Drain Pump Runs Continuously ( Updated ) |
| Video Uploader | Video From Rod Ross |
| Upload Date | This Video Uploaded At 27-04-2020 03:39:54 |
| Video Discription | This is a new ( as of April 26th, 2020 ) video. God bless! Please read to the end since important information is at the end. My drain pump continued to run even after turning off the washer. The only way I could get the pump to stop was to unplug the washer for several minutes but again when I plugged the washer back in and pressed the power button and the pump ran without ceasing. I do believer this to be a firmware error that is reset with a hard reset when doing these steps. I assume no responsibility for anyone's actions and I am only showing what I did. Basically, I opened the control module panel and lightly tapped on the the small round black capacitors which hold a charge, making sure I was insulated ( using plastic ) and not touching anything that would shock me. I also sometimes check the wire connections to see if they are loose or for any play and pressed the connectors back in securely. I used to repair circuit boards in computers a very long time ago and there is nothing wrong with this board, only that it needed a hard reset much like a Casio watch does when you change out the battery. This is a firmware error that the factory needs to address and doing these steps sometimes allows for a hard reset or hard boot by draining all of the electrical charge out of the capacitors. Replacing the control module board with another new control module board with the same firmware will not resolve any firmware input, output errors. So, purchasing another new circuit board with the same firmware is costly and worthless since this is a firmware issue and not a hardware issue. The same firmware error will eventually reappear with even a new control module board. This is an issue that LG needs to address with a proper firmware update fix. The only temporary fix I have found is to fully reset the washer by draining all of the electrical charge out of the control module programmable memory which is what a hard reset is. So far I have only had to do these steps once a month or less and have been successful but sometimes the reset requires 3 attempts at doing these steps before the washer fully resets. This may seem primitive but the objective is to remove any and all electrical charge from the control module to clear all errors. I am a former CTG/ISSC ( IBM programming division ) employee who has also worked on a Debian team with people who wrote firmware for GNU/Linux in the past. You may find my original silent video here: https://www.youtube.com/watch?v=fFgMrTmOM8M God bless! 1X74paodnkk |
| Category | Science & Technology |
| Tags | LG WT1101C* | LG T1201C* |
